| the aeromotive one im looking at (FPR) has a 1:1 raising rate
regarding low pressure and high pressure pumps, i need to work out rough requirements.
originally i was going with a low pressure facet red top " works" pump (35 gallon per hour-159 litres per hour @ 6.5-7.2 psi -0.44bar) this was going to feed a 1.5 litre swirl pot then a sytec high pressure pump (34.31 gallons per hour-156 litres per hour @43 psi - 3 bar) would feed the fuel rail
however.......
i read the facet pump is only good to feed for 200hp, im aiming for 400-450
so my Q to the experts is......are the figures above upto running a 2.2 4 cylinder or should i look at something with a little more flow.
i am looking at aeromotive stuff and they have some serious high flow high pressure pumps.....but nothing to feed a swirl pot.
could 2 Facets be used to flow the required amount?, and then use 1 high flow high pressure pump to feed the rail, if so what sort of flow @ what pressure am i needing to find |