Quote:
Originally Posted by howler  * * 4-6. (PRO-AM) Vehicles must have FIA approved racing seat for the driver and does not have to be in date but must be in good condition. i.e. not showing any signs of stress, cracks or damage to the structure of the seat and Fixed using a minimum of four 8mm bolts (ISO 8.8) and 5 sq inch spreader plates
Does this mean that using my driftworks subframe ( http://www.driftworks.com/catalog/pr...ight-side.html) is no good?
Not actually measured its moutning surface but not sure it will be 5 inch square? |
I had similar concerns earlier this year with the EDC regs. The answer from Marc (Scrutineer) was that as long as the seat is secure then it will be fine. The 5" plates are to be used if the seat is bolted directly through the floor rather than on the original seat mounting points.
Just quote and give us a
if this still applies Marc, saves your poor little fingers from wearing out.
