Drifting forum - Driftworks - View Single Post

xborninthefightx · 31-01-2008, 20:39

I sorted out the front shocks with the hight, its not too low, and Ive sorted the dampening to soft, it was a very hard ride. Now its much better not as good in the corners but its still good. But then i fitting the Strut Braces and that helped too

Oh yeah got some new rubber and this is wat happened the other day as i was going around the corner (a little too hard) and went over a pot hole and i think it jumped a bit (the car) and I hired a very loud bang.

Thats wat you get when you spend £20 for a new tyre

, (I know Im a cheap bastard)

Then i started fitting the body kit and only got as far as fitting the front bumper on.... very badly

Here is the new one

Its a real pain taking the old one off, soo many screws but after a few hours it looked like this

I got this idea from Lex when i met him at the Final Round of the EDC. This was a new thing for me, till i started seeing that everyone on here does it

. So was going to do the same

Heres a little test fit

I used 7 wires in the engine bay as you can see.

2 wires on the side and another 2 on the inside which you can see

Only problem is that its a real shitty fit.

Also had to take off the shock bar thingy, getting in the way, Its not the best thing to drive without one as a daly car.

(safety first)

This is wat it looks like, its not that bad could be worse.

You can see that the ride hight is much better in this pic.

lets see how bad the others will look.

31-01-2008, 20:39	#21 (permalink)
xborninthefightx dorifto kingu! Join Date: May 2007 Location: Ashford, Middlesex Posts: 771	I sorted out the front shocks with the hight, its not too low, and Ive sorted the dampening to soft, it was a very hard ride. Now its much better not as good in the corners but its still good. But then i fitting the Strut Braces and that helped too Oh yeah got some new rubber and this is wat happened the other day as i was going around the corner (a little too hard) and went over a pot hole and i think it jumped a bit (the car) and I hired a very loud bang. Thats wat you get when you spend £20 for a new tyre , (I know Im a cheap bastard) Then i started fitting the body kit and only got as far as fitting the front bumper on.... very badly Here is the new one Its a real pain taking the old one off, soo many screws but after a few hours it looked like this I got this idea from Lex when i met him at the Final Round of the EDC. This was a new thing for me, till i started seeing that everyone on here does it. So was going to do the same Heres a little test fit I used 7 wires in the engine bay as you can see. 2 wires on the side and another 2 on the inside which you can see Only problem is that its a real shitty fit. Also had to take off the shock bar thingy, getting in the way, Its not the best thing to drive without one as a daly car. (safety first) This is wat it looks like, its not that bad could be worse. You can see that the ride hight is much better in this pic. lets see how bad the others will look.