How To Fit A Air & Fuel Gauge - Drifting forum

matty k · 06-08-2008, 21:37

do anyone no wot colour u av 2 connect signal wire to on the oxygen sensor thanks

Car Media · 06-08-2008, 21:48

try spell check

LiGhTnInG · 06-08-2008, 23:53

Your lambda sensor has three wires.

2 are +- voltage.

1 is sensor.

it'll be obvious, as the two for power are similar colours. The sensor wire is a different colour.

steve_fctuning · 07-08-2008, 01:35

white wire i believe
unless the car is warm it will take a little time to respond on your gauge anyway until the sensor has warmed up

06-08-2008, 21:37	#1 (permalink)
matty k gripper Join Date: Aug 2008 Posts: 5	How To Fit A Air & Fuel Gauge do anyone no wot colour u av 2 connect signal wire to on the oxygen sensor thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-08-2008, 21:48	#2 (permalink)
Car Media Doughnut Eater Join Date: Aug 2007 Location: Sunny, Suffolk Posts: 392	try spell check

06-08-2008, 23:53	#3 (permalink)
LiGhTnInG Doricomotion Join Date: Aug 2005 Location: DriftRacing.co.uk Posts: 8,806	Your lambda sensor has three wires. 2 are +- voltage. 1 is sensor. it'll be obvious, as the two for power are similar colours. The sensor wire is a different colour.

07-08-2008, 01:35	#4 (permalink)
steve_fctuning touge runner Join Date: May 2007 Location: London Posts: 196	white wire i believe unless the car is warm it will take a little time to respond on your gauge anyway until the sensor has warmed up