
Contact - 0845 86 92 555
sales@driftworks.com
03-10-2008, 15:14
| #1 (permalink) |
| DRIFT RETARDED Join Date: Nov 2006 Location: ESSEX AIN IT BRUV
Posts: 652
| 200sx warning lights?????? i noticed a red box with pipe/ lines and wave line s above the box after i stopped i see the cat sensor from the old cat had been scraping the floor also twice today while driving my revs dropped to 1k rpm and wouldn't car wouldn't move or rev so after sitting for a minute i tried revin it again and all was fine these connected? |
| |
04-10-2008, 17:51
| #2 (permalink) | |
| DRIFT RETARDED Join Date: Nov 2006 Location: ESSEX AIN IT BRUV
Posts: 652
| Quote:
| |
| |
04-10-2008, 18:51
| #8 (permalink) |
| DRIFT RETARDED Join Date: Nov 2006 Location: ESSEX AIN IT BRUV
Posts: 652
| im confused i asked on the sxoc and was told to cut the sensor off.... it was snapped anyway so i took the sensor off and started the car and the light had gone but after covering the wire the light came on again! |
| |
04-10-2008, 20:59
| #10 (permalink) |
| DRIFT RETARDED Join Date: Nov 2006 Location: ESSEX AIN IT BRUV
Posts: 652
| right been out yet again and it cut out 3 times !! i'll explain again what happens as this time i had a better look, i pulled out a junction and just lost all power and go, the car was just idle ing and if i tried to rev it even foot to the floor! then it would rev from 1k rpm upto 1.4k rpm n drop straight back down to 1k rpm i turned engine off for a couple of minutes then it was ok again |
| |
05-10-2008, 19:18
| #16 (permalink) | |
| Doricomotion ![]() | Quote:
| |
| |
06-10-2008, 00:12
| #17 (permalink) | |
| DRIFT RETARDED Join Date: Nov 2006 Location: ESSEX AIN IT BRUV
Posts: 652
| Quote:
![]() | |
| |
![]() |
| Thread Tools | |
| Display Modes | |
| |