richy d
Last Activity:
Dec 8, 2016 at 8:28 AM
Jun 26, 2009
Trophy Points:
Positive ratings received:
Neutral ratings received:

Post Ratings

Received: Given:
Like 0 0
Dislike 0 0
Funny 0 0
Winner 0 0
Informative 0 0
Useful 0 0
Optimistic 0 0
Creative 0 0

Share This Page

richy d

Active Member, from birmingham

richy d was last seen:
Dec 8, 2016
    1. shaggy_master
      Hi mate I'll take the BBS
    2. covjdm
      I will take the splitter mate, can you PM your postcode as Iam only in Coventry and can come collect it tomorrow night mate

    3. Danny_Boy
      Hello mate, I have searched and you seem to be the man in the know with mx5's and turbos. I just stuck a gt1752r off a Saab 9-5 on my 1.6 eunos, intercooler etc. But I'm having a right issue with the running. I have fitted a rising fpr to the car but it's going right round to red on the afr gauge and I'm not even at half throttle.

      If I hold at like 30% it runs ok, stays in the yellow but as soon as you apply more, red and the car dies.

      I have attached the white wire from the wideband to the ecu and changed it to a 0-1v reading but don't think that would cause anything.

      I have the actuator set to the lowest level so it slots over the wastegate arm with ease also and just running actuator pressure. Retarded to 6-7 deg timing.

      I'm at a loss mate, could the fpr be dead?

      I have it connected up correctly as far as I know.

      Sorry for the massive message!! Any help would be amazing mate.

    4. TeamCommit
      Would you take 400 for full car or 300 for car without hydro ans seats. .. I just need it for engine conversion lt me know aap can give deposit to secure. ..
    5. TeamCommit
      400 quid for all lot. 300 for all car without hydro and bucket seats. ..
    6. TeamCommit
      Hi replied on thread about car... if e can sort summat I will put deposit in for it
    7. Jdizzle91
      Hi m8 i see on here that you know alot about a turbo mx5! Right i have a 1.8 uk spec and making a turbo setup so heres the parts i have already.... T25 200sx turbo, begi manifold + downpipe, oil feed/return lines, im gonna buy a intercooler soon plus some rx yellow top injectors and then a megasquirt pnp is that everything i need?
    8. mattwho
      hi mate ive just seen you telling a guy on his mx5 turbo build you can get a turbo mani made up??? can you still do this and how much will it cost??? ive been after turboing mine for ages but it just is to much money!!!

    9. Ricky_Mitchell
      Clear your inbox.
  • About

    wmp fleet technician
    mx5 turbo