My nissan s13 build don't know if I'm using the thread right here it goes just some lil bits ive done to the car
{} {} {} removed the bad engine on the road lol and hate how the engine bay was messy to cleaned it up
{} {} {} welded up the engine bay also decide to weld up the 100 useless bold holes and smooth the bay abit
{} {} decide to do the interior also and took the dash out and the sounding pads are a bitch to remove
{} engine dropped back in with a new stage 2 excedy clutch fitted temp turbo and inlet on to drop the engine back in lower front stone chipped to prevent rusting again.
{} {} {} {} {} got a barain on cs recaro seat so it was a must mod for me. refitted the interior installed the a new short shifter and cut and modded cs recaro seats with tegiwa s13 rails to fit in the s13 was a big job and its a good thing I'm 5ft6 as if your 6ft you will need bride super low rails
{} {} {} sorted out the exhaust as wasn't happy with it fitted new polybush rubbers and a new decat flexi/turbo elbow/downpipe also titainium heat wrapped it all used 40meters of the wrap (was just enough).
{} {} got a deal on an apex cage just need to paint it shimmer candy red with my engine bay bits and fit em also bought 5 stud swap kit with s14a calipers. now just awaiting payday to buy some paint and disks and finish off engine bay and the car and get it running
So i decided to clean up the outa front end was surprised how good it was for being a really old car only a couple spots of surface rust so sorted that out. Gave it a clean and rust protector and a coat of stonechip looks alot better also refitted the radiator. {} {} {} {} {}
picked up this 5 stud front swap kit front japwestmods and the rear hubs from tegiwa got a good deal cost me £330 in total front hubs turned out to be from gt-1 from japan and are nearly new they cost 250 each on there website so mega happy with these. I could have got a cheaper set but wanted new bearing as didn't want the hassle of having to replace them later. {} {}