Separate names with a comma.
got some more of the plate cut and tacked in place for the front supports, couldnt help but throw some paint down to see how it would look...
No major progress recently, between chris off racing overseas and work we have been pritty flat out. slowly collecting parts for the front...
i will upload a few photos and updates shortly
Render was done through a small business I have a part in. Each render is custom made from scratch however the client specifies.
Cheers mate. Hoping to get cracking on the tube front this weekend.
Did a render of what the car could look like once we have finished with the build. [ATTACH]
Started welding up a remote mounted hydro setup today. Means we can run the master behind the drivers seat and only need to run a handbrake lever...
And the fabrication begins. Made some templates from some scrap cardboard which ill transfer to 2mm sheet steel. So far i have made plates to cap...
Boot was next on the chopping block prepping for a tubed bash bar and a fuel cell. A good chunk of weight removed so far. Still have the other...
After stripping the front end and pulling the motor and trans it was time to give the engine bay a bit of a tidy up. We decided we were going to...
Bit of a run down on the car prior to it being put up on jack stands. As mentioned above the car is an 325i sedan, Motorsport and manual....
Bit of an introduction, We are 2 mates from New Zealand, We are in the process of building an e36 drift car. 90% of the fabrication will be done...