Separate names with a comma.
I've just bought another ep3 type r and it came with an injen long arm induction kit fitted, the one where the fitter sits down in the front...
I've never had a bmw before and quite fancy trying one. Ideally I'd like and e46 m3 bit can't quite afford one at the moment so am looking at...
Quite fancy a 350z and currently have a 6 spee manual altezza rs200 that I'm looking to do a trade with. Good spec and condition with quite a bit...
Heres my set of work Vs Mx edition 3 piece split rims. Ive stripped them down and sent the lips off and had them powdercoated gloss black. The...
I have a set of Project Mu Racing Floating Wheel nuts still in the box as new. They retail at over £135. They are 1.5 thread which fits Toyota,...
I'm after a spare flywheel for my altezza rs200 manual gearbox. I want to get it lightened and ready to fit when I get a new clutch. Can't be...
I'm after a standard airbox for my altezza rs200. It currently has a sard hard pipe Induction elbow fitted with sard silicone joiners and and...
Hey guys I'm after front and rear lips and side skirts for my altezza and maybe a rear spoiler. Might even be Interested in the TTE front bumper...
I'm after the center section exhaust for an altezza with the 3sge engine. I'm looking to decat the system and would like to replace the whole cat...
Ive got the standard leather steering wheel from my altezza up for grabs as i replaced it with a deep dish one now. Comes complete with the airbag...
I'm looking for a decat for my altezza. If anyone's got one up for grabs let me know. Also if there's any downsides to fitting one as I have a 1...
Im after an aftermarket rear box for my altezza. Would like the jap can style if possible and i want a direct bolt on rear section not a weld on...
I have a pair of brand new in the box caterpillar holton boots. There steel toe cap safety boots. Black leather and never been worn. They are...
Just fitted a stainless manifold to my altezza so the standard one is up for grabs. No damage or cracks at all. As this if off a manual altezza it...
Hi guys ive just fitted a deep dish aftermarket steering wheel on my altezza. firstly i know i need to wire a resistor to put the airbag light out...
Hey guys i bought a set of work Vs Mx edition 3 piece split rims a few months ago. Stripped them down and sent the lips off and had them...
Hey guys I've got a spare front passenger side fog light or an altezza or is200. In good condition with no damage or cracks etc. Also have a roof...
Hey guys im after the side skirts and front and rear lips for my altezza. Don't want any cheap fibreglass crap that needs to be screwed on like...
I e it a set of four ht leads which came off of my Mazda rx8. The car had low mileage and they all work fine with no damage. I upgraded to the...
Hi guys I just ordered a stainless steel 4-1 manifold for my altezza and already have an aftermarket rear box. Now I'm looking into removing the...