Separate names with a comma.
Bump
Standard s14a wheels. Tyres are done as they’ve been sat in storage for years. Do as a set of skid wheels. Some keeping as shown by photos to 3 of...
Blitz bov looking for £70 in good working order. Taken off my starlet years ago and has sat in storage since [ATTACH] [ATTACH] [ATTACH]
Cheers. No real progress over Christmas and I’ve got a mates z32 rear brakes to overhaul but I’ve got a ton of TIG work to do shortly before the...
Next up is to anodise the surround itself, fit up the gauge panel and then anodise that. I need to get a bigger pan to seal these in as I don’t...
So I got round to machining up some gear gaiter dress up parts. Turned my hand to anodising these as well today. Quite impressed at the end result...
The whole situation is a shambles by both of them really.
OEM igniter for sale from a 97 s14a. Also have plugs and tails if required. £30 plus postage [ATTACH]
Ordered some TIM electric oil pressure and water temperature gauges. Just need to make the gauge panel fit the spare din slot and anodise before...
Finally got the lathe up and running so I machined up an air fitting for the compressor housing [ATTACH] [ATTACH] [ATTACH] [ATTACH]
I’m not entirely sure how this is a ‘smear campaign’ to be honest, or how OP is to blame for it. Hitting the limiter once and not realising where...
Back to the main topic of this thread. I’m not entirely sure where I’m going from here. There’s a few more bushes to replace here and there and...
Next up was the inlet ports. These weren’t quite as bad as the exhaust ports so they were opened out slightly, casting marks removed and then...
Next up was removing the blob at the top of the chambers near the spark plugs and polishing the chamber tops. These were heavily coated in carbon...
The exhaust ports before, during and after. As you can see they’re not even straight and very small. I opened them out a bit and highly polished...
Bit of a side note but an interesting one for some I think. Suitably impressed with my results I got asked by my brother in law to port the...
So once again not much happened with that car for a year until February 2019 when I rebuilt the turbo that was smoking quite a lot. In hindsight I...
20 year old engine mounts: meet stage 4 clutch. They had a good innings but all 3 had broken. [ATTACH]
February rolled round and I was scratching around for a couple of jobs. I’ve never liked how much slop there was on the shifter cage, so I had a...
I’ve had some fuelling issues for some time So I set about trying to chase the problem. I ordered this direct from Japan just before Christmas and...