First question, I am not near my car and need to know the diameter of my Fabricage pipework. It's just a bolt in 6 point for an S14a. I also need to know where I can get a couple of meters of this same pipe tomorrow. (I am in Surrey) Any help on the subject would be much appreciated. :-)
wont be t45 seamless, just cold drawn seamless (cds). i would imagine the cage is 45mm diameter and should be 12g thickness. i have some 45mm 12g tube if you need some dan. (and im in surrey) btw i havnt forgotten about your pm, just been mega busy and have not had a chance to check my notes, will look for u in a min and pm you. nick