I recently installed a chip from turbonoz in my 180sx sr20det ecu. I tried in an E5 and a 62 ecu but it doesn’t seem to be working. It’s as if the ecu isn’t reading the chip at all. I have triple checked my soldering on the manifold and the jumper CJ1 to CJ2. The red light on the ecu just stays on. It idles rough and over fuels. Am I supposed to do something else to make the ecu read the chip? Thanks.
Have you e-mailed Noz about the problems? You can muller the chip if it's accidentally soldered in backwards can't you??
Have you tried on Facebook? People used to be able to get hold of him on that. https://www.facebook.com/Turbonoz https://www.facebook.com/NoelUhure
I have tried the fb page but I’ll try his personal page now! Thanks for that. I have read only good things about noz so it’ll be nice to get it going the way it should!
It's a bit of a thread revival, but does anybody have any contact with Noel/Turbonoz? I have tried emailing, calling and contacting via Facebook but have had no response.