Green Dots - Rear lower arm bush.
4 required when using standard lower arms.
Orange Dots - Upright and control arm bush.
10 required with all standard control arms.
6 required when used with a Driftworks Four Arm kit.
HICAS equiped cars require 2 less ‘upright and control arm’ bushes.
To fit the bushes first burn out the old rubber bush:
Then, remove the steel collar from inside the housing, this it most easily done by slotting with a saw, then bashing out:
Lubricate the Driftworks poly bush, and push it in. You need to pull the lips outside of the hub/arm to seat the bush properly - be careful not to tear it! Then push the steel insert into place. You may need to use a clamp/vice depending on how strong you are!
*Pictures are of a rear lower arm, but the bush removal is exactly the same.
- Shipping Price
Shipping PriceWe ship worldwide!
Finance CalculatorUse this calculator to see which finance option suits your purchase.
Finance is subject to status. Terms and conditions apply.Deposit of , followed by monthly repayments of . Total amount payable . APR representative.
Write Your Own Review